System Debug Reference Manual (32650-90888)

332 Chapter9
System Debug Window Commands
wE
GD Group window
UD [ win_number ] User window
VD [ win_number ] Virtual window
ZD Real memory window
LD LDEV window
TXD [ win_number ] Text window
This command causes the window to be removed from the screen temporarily until the
window is enabled again (see the wE command). Current window attributes (such as size,
address, contents, and so on) are retained between disable/enable calls.
Parameters
win_number The window number for a specific user window (U), text window (TX), or
virtual window (V). If
win_number is omitted, then the current window is
used. The current user window is marked by an asterisk, and the current
virtual and text windows are marked in inverse video.
Examples
%cmdebug > PD
Disable the (current mode) program window.
%cmdebug > UD 3
Disable user window number 3.
Limitations, Restrictions
none
w E
Window enable.
Syntax
RE CM registers
GRE NM general registers
SRE NM special registers
PE Program, current mode
CMPE CM program
NMPE NM program
QE CM Frame, Q relative
SE CM Stack, S relative
GE Group window
UE [ win_number ] User window
VE [ win_number ] Virtual window