STORE and TurboSTORE/iX Products Manual (B5151-90003)

62 Chapter4

Preparing the System

Temporarily Suspending Jobs

It is advisable to suspend the execution of all jobs while a STORE is being performed. (If a

job step attempts to open a ﬁle for write access which is being stored, the open fails, with

possible negative consequences for the job.)

NOTE

Advise users not to schedule jobs during the time schedule for backups.

STORE does not copy ﬁles opened by suspended jobs. Therefore, a backup

undertaken with suspended jobs may be incomplete.

To check whether there are any jobs running on the system, enter:

:SHOWJOB JOB=@J

If you see a message stating NO SUCH JOBS, or if the list contains no executing jobs (check

the STATE column for EXEC), skip to the "Send Another Warning" step below. If any jobs

are in the EXEC state, you should temporarily stop them. To do so, use the job numbers

that appear in the ﬁrst column on your screen with the BREAKJOB command, as follows:

:BREAKJOB #Jnnn

Repeat the BREAKJOB command for each executing job in the list. When you have

suspended all executing jobs, check their status by entering:

:SHOWJOB JOB=@J

Each job should now be listed as SUSP, or suspended. However, jobs that have resources

allocated to them do not suspend immediately; you may have to wait for them to suspend.

NOTE

For an online backup, suspend all active jobs until you receive the message on

the console telling you that ﬁles can now be modiﬁed. At that point, you can

resume any jobs that you suspended before the backup starts.

For a 7x24 true-online backup, you do not need to suspend any active jobs

before starting the backup. They can continue to run throughout the backup.