STORE and TurboSTORE/iX Products Manual (B5151-90003)

152 Chapter10
Backing Up the System Configuration
The System Backup Command
NOTE The warnings refer to the network manager configuration file, which
configures remote devices and terminals on the system. SYSGEN is
concerned with the devices actually interfaced to the system.
The System Backup Command
The SYSGEN command that you use to make a system load tape is TAPE (TA).
To create a system load tape without additional files, enter the following command:
sysgen>TAPE
or
sysgen>TA
At the end of the tape creation, you receive the following message:
** Boot backup generated successfully **
If an error occurs during the tape creation, a flashing TAPE ERROR message is issued to the
console, describing the error.