SNA NRJE User/Programmer Reference Manual (30292-90006)

Chapter 3 69
User Commands
DISPLAY
When you enter DISPLAY INFO, or DISPLAY without any parameters,
the State of a workstation is one of those described in Table 3-2.
The information that DISPLAY provides is presented one screen at a
time if the command is issued from an interactive session.
Table 3-2 Workstation States
State: Meaning:
ACTIVE
The workstation is connected to the host job entry subsystem.
STOPPEND *
One of these has been issued and is pending:
• An NRJE subsystem STOPWS command.
• An NRJE subsystem NRJEStopWS intrinsic call in stop mode.
• One of these MPE commands:
NRJECONTROL STOP ...
SNACONTROL STOP ... ; TYPE=Q
SHUTPEND * One of these has been issued and is pending:
• An NRJE subsystem HALT command.
• An NRJE subsystem NRJEStopWS intrinsic call in halt mode.
• The MPE command SNACONTROL STOP...; TYPE=P
MONPEND The NRJE monitor process has been activated, but the LUs are not
yet active.
PENDING * The NRJE monitor process has not yet been activated.
NACTIVE The NRJE monitor process has not been created, and no STARTWS
NRJE subsystem command, NRJEStartWS intrinsic call, or
NRJECONTROL START MPE command has been issued.
* This is a highly transient state.