SNA NRJE User/Programmer Reference Manual (30292-90006)

34 Chapter1

Introducing SNA NRJE

HP 3000 Hardware and Software Requirements

HP 3000 Hardware and Software

Requirements

Hardware Requirements

The HP 3000 hardware requirements for SNA NRJE are as follows:

• An HP 3000 Series 37, 39, 4x, 5x, 6x, or 7x that supports an

HP 30020A/B/C Intelligent Network Processor (for NRJE/V).

• A HP 3000 900 Series that supports an HP30263A Programmable

Serial Interface (for NRJE/XL).

• Communications line, leased or switched.

• These modems are supported:

HP 37230A up to 9600 bps

Bell 201C 2400 bps

Bell 208A/B 4800 bps

Bell 209A 9600 bps

Bell 2024A 2400 bps

See the Data Communications Handbook, Fundamental Chapter for

communications conﬁgurations and strapping options.

• A block mode terminal in addition to the system console for Node

Management Services conﬁguration. This terminal must be

supported by VPLUS. See the SNA Link Services Reference Manual

or the SNA Link/XL Node Manager’s Guide.

Software Requirements

HP 3000 software requirements to run SNA NRJE are as follows:

• MPE V Operating System: HP 32033G (for NRJE/V).

• MPE XL Operating System (for NRJE/XL).

• SNA Link/V: HP 30246A (for NRJE/V). This enables SNA NRJE to

communicate with the host job entry subsystems in the SNA

environment.

• SNA/SDLC Link/XL: HP 30291 (for NRJE/XL).

• SNA/X.25 Link/XL: HP 30298 (for NRJE/XL).