SNA NRJE Node Managers Guide (30292-90007)

Chapter 3 47
SNA NRJE Configuration
Configuring SNA NRJE
Host Configuration:
• JES2: This must be less than or equal to the
NUMRD
parameter of the RMT nnnn macro; see Table 3-4.
• JES3: This must be less than or equal to the
RD
parameter of the RJPWS macro; see Table 3-6.
• VSE/POWER: This field is ignored (because one
reader is assumed).
Compression On
Required. Enter Y if the host accepts compressed
in-bound data; N, otherwise.
Default: Y
Host Configuration: This must match the
PRIPROT
parameter of the MODEENT macro in the Logmode Table
entry used by this workstation (VTAM); see Table 3-2.
• JES2: If you specify Y, the
COMP parameter must be
specified in the RMT
nnnn macro for the workstation;
see Table 3-4. Starting with version 3 (or later) of
JES2, use COMPRESS=YES instead of COMP.
• JES3: Does not apply.
• VSE/POWER: You must specify N, because
VSE/POWER does not support compressed in-bound
data.
File
For display only. The name of the configuration file.
Once you have configured the readers for the
workstation, press [f6] [Save Data].
After the information is processed, press
[f8]
[Prior Screen] until you get back to the NRJE
Configuration: Workstation Data screen. Then, if you
need to configure the virtual writers for the
workstation, press
[f3] (Go To WRITER). Otherwise,
press
[f8] [Prior Screen] until you get to the NMMGR
menu screen or select screen you need next.