SNA NRJE Node Managers Guide (30292-90007)

38 Chapter3
SNA NRJE Configuration
Configuring SNA NRJE
Host Command Prefix Char
Required. The character preceding all host console
commands.
Host Configuration:
• JES2 and JES3: The command prefix can be
configured; this parameter must match the prefix
specified in the host job entry subsystem
configuration.
• VSE/POWER: The value entered here is used
interactively only. VSE/POWER commands must be
entered using this prefix. Any non-interactive
VSE/POWER command must still be preceded by
*∆ . . ∆
(∆ represents a blank).
Allowed Host Commands
The host commands users without NM capabilities are
allowed to include in jobs submitted to the host.
Multiple commands can be specified by separating
them with semicolons (;). NRJE will compare the value
(up to the first blank character) in this field with the
command entered. If the characters match, the
command is transmitted to the host.
Default: All blanks
Examples:
Allowed Host
Commands Explanation
$D Allows all JES2 commands that start
with “$D”.
$D; $C; $L Allows all JES2 commands that start
with “$D”, “$C”, or “$L”.
$ Allows all JES2 commands.
*I Allows all JES3 commands that start
with “*I”.
all blanks No commands are allowed.
Auto Recovery
Required. Enter Y if you want NRJE to try to recover
if SNA Transport reports a link error; NRJE will keep
trying to recover until it is successful.
Default: Y