SNA NRJE Node Managers Guide (30292-90007)

Chapter 3 37
SNA NRJE Configuration
Configuring SNA NRJE
Default: Blank (use the first entry in the Logmode
Table)
Host Configuration: This must match the LOGMODE
parameter of the MODEENT macro in the Logmode Table
entry used by this workstation (VTAM); see Table 3-2.
APPLID
Required. The VTAM application identifier for the
host job entry subsystem. If you do not know the correct
identifier to enter here, ask the host system
programmer.
Host Configuration:
• JES2: This must match the
APPLID subparameter of
the LOGON
n global parameter; see Table 3-3.
• JES3: This must match the
APPLID subparameter of
the
COMMDEFN global parameter; see Table 3-5.
Term Password
The terminal password. You must type the case (upper
case or lower case) of each character exactly as it was
specified on the host.
Default: Blank (no password)
Host Configuration:
• JES2: This must match the
PASSWORD parameter of
the RMT
nnnn macro; see Table 3-4.
• JES3: Do not specify.
• VSE/POWER: Do not specify.
Workstation Prompt
Required. The prompt for terminal users of this
workstation. Leading or imbedded blanks are not
removed.
Default: The greater-than sign (>)
Console Mode Prompt
The prompt for the owner of the workstation console.
Default: Blank (no prompt)
Job Entry Subsystem
Required. The subsystem the host is running. Enter
JES2, JES3, or POWER (for VSE/POWER).