SNA NRJE Node Managers Guide (30292-90007)

246 AppendixA
Result Codes and Messages
SNA NRJE Logging Messages
ACTION: Refer to the message logged immediately prior to this one for
information on FSERR. Stop the workstation and purge any files in the
group NRJE.SYS with the names TH
nnnnn and FH nnnnn , then restart
the workstation. If the error is encountered a second time, contact
Hewlett-Packard for assistance.
9090 MESSAGE: NRJE(!:!): CANNOT ROUTE TO A NEW, DISC FILE
OUTSIDE OF THE SYS ACCOUNT. JOB NUMBER= !. OUTPUT
ROUTED TO DEFAULT DESTINATION WITH PRIORITY = 2. (LU=9090)
CAUSE: An attempt was made using a Lookup Table entry to route to a
new disk file outside of the SYS account which is not allowed. NRJE
cannot save new files across account boundaries.
ACTION: Delete any Lookup Table entries which attempt to direct
NRJE to build files across account boundaries. Output should be routed
to permanent disk files built by the user if routed outside of the SYS
account. Alternately, output can be routed to new files in the SYS
account but this can be done only once for each file. A second
alternative is to use REVERSE NRJE to stream a job which can then
build files in alternate accounts.
9091 MESSAGE: NRJE(!:!): NEW DISC FILE RENAMED DUE TO DUPLICATE
PERMANENT FILE. JOB NUMBER= !. OLD FILE NAME = !. NEW FILE
NAME = !. (LU=9091)
CAUSE: NRJE could not save a new disk file in the permanent domain
due to a duplicate permanent file which already existed by this name.
NRJE therefore saved the file with the new name of NRJE
nnnn where
nnnn represents the time (hours/minutes) at which the file was
renamed.
ACTION: If a dataset is to be routed on a continual basis to the
permanent disk domain then it should be routed to a permanent disk
file. Replace the offending entry in the Lookup Table with one which
uses the default domain of “old, permanent”.
9092 MESSAGE: NRJE(!:!): FAILED TO RENAME OUTPUT FILE. JOB
NUMBER = !. NEW NAME ATTEMPTED = !. (LU=9092)
CAUSE: Output was routed to a new disk file which could not be closed
to the permanent domain due to a duplicate permanent file of the same
name. NRJE attempted to rename the output file to NRJE
nnnn but this
rename failed. The output for the data set was lost.
ACTION: If a dataset is to be routed on a continual basis to the
permanent disk domain then it should be routed to a permanent disk
file. Replace the offending entry in the Lookup Table with one which
uses the default domain of “old, permanent”.
9093 MESSAGE: NRJE(!:!): FAILED TO LOCK NRJE XDS. STATUS=!
(LU=9093)
CAUSE: Internal error.