SNA NRJE Node Managers Guide (30292-90007)

190 AppendixA
Result Codes and Messages
SNA NRJE Error Messages
ACTION: An LU name must begin with a letter and may be eight or
fewer alphanumeric characters long. Correct the information and
re-enter the data.
715 MESSAGE: NEW PRIORITY MUST BE BETWEEN 0 AND 14. (CI=715)
CAUSE: An invalid new priority value was entered.
ACTION: A priority must be between 0 and 14. Correct the information
and re-enter the data.
716 MESSAGE: INVALID USER.ACCOUNT. (CI=716)
CAUSE: An incorrect
UserName.AcctName was entered.
ACTION: Verify that the
UserName and AcctName exist. A UserName and
AcctName must each begin with a letter and may be eight or fewer
alphanumeric characters long. One must be separated from the other
by a period.
717 MESSAGE: INVALID WORKSTATION ID. (CI=717)
CAUSE: An invalid workstation identification was entered.
ACTION: Verify that the workstation identification exists. A workstation
must begin with a letter and may be eight or fewer alphanumeric
characters long. Correct the information and re-enter the data.
718 MESSAGE: LENGTH OF THE WORKSTATION ID IS OUT OF RANGE.
(CI=718)
CAUSE: The workstation identification contains too many, or too few
characters.
ACTION: A workstation identification must begin with a letter and may
be eight or fewer alphanumeric characters long. Correct the
information and re-enter the data.
719 MESSAGE: NEW PRIORITY IS EXPECTED. (CI=719)
CAUSE: The new priority value was omitted.
ACTION: Correct the information and re-enter the data.
720 MESSAGE: NO PARAMETER IS EXPECTED. (CI=720)
CAUSE: A superfluous parameter was entered.
ACTION: Correct the information and re-enter the data.
721 MESSAGE: NO SUCH COMMAND. (CI=721
CAUSE: An unknown command was entered.
ACTION: Correct the information and re-enter the data.
722 MESSAGE: NO SUCH COMMAND OR PARAMETER. (CI=722)
CAUSE: An unknown command or parameter was entered.