SNA NRJE Node Managers Guide (30292-90007)

148 AppendixA
Result Codes and Messages
SNA NRJE Error Messages
129 MESSAGE: LU NAME IS NOT CONFIGURED FOR THE
WORKSTATION. (INT=129)
CAUSE: Attempt to activate or deactivate an LU that is not configured.
ACTION:
130 MESSAGE: LU IS ALREADY ACTIVE. (INT=130)
CAUSE: Attempt to activate an LU that is already active.
ACTION:
131 MESSAGE: STOP OR HALT IS INVALID IF WORKSTATION IS NOT
ACTIVE. (INT=131)
CAUSE: The workstation may not have been started or another NRJE
manager may have already stopped or halted the workstation.
ACTION:
132 MESSAGE: UNABLE TO OBTAIN A LIST OF ACTIVE LUS. (SEV=132)
CAUSE:
ACTION:
133 MESSAGE: STOP OR HALT CODE IS NOT 0 OR 1. (INT=133)
CAUSE: The
StopCode parameter passed to the NRJEStopWS intrinsic is
out of range.
ACTION: Correct the StopCode parameter value.
134 MESSAGE: LU IS NOT ACTIVE. (INT=134)
CAUSE: An attempt was made to deactivate an LU that is not active.
ACTION:
135 MESSAGE: LU NAME MUST BE SPECIFIED SINCE WORKSTATION IS
ACTIVE. (INT=135)
CAUSE: Attempt to start workstation was made but it is already active.
ACTION:
136 MESSAGE: UNABLE TO OBTAIN A LIST OF CONFIGURED LUS.
(INT=136)
CAUSE: Possible configuration error.
ACTION: Check configuration file for correctness and retry.
137 MESSAGE: NUMBER OF LUS INPUT IS !. IT MUST BE BETWEEN 1
AND !. (INT=137)
CAUSE: The
MaxEntries parameter passed to the NRJELUList intrinsic
was out of range. The first ! parameter of the message is the