SNA NRJE Node Managers Guide (30292-90007)

140 AppendixA
Result Codes and Messages
SNA NRJE Error Messages
35 MESSAGE: NRJEERRMSG CALL COMPLETED IN ERROR STATE.
(INT=35)
CAUSE: This error might be caused by a variety of reasons, such as (1)
unable to open the file NRJECAT.NRJE.SYS, (2) system administrator
has changed NRJECAT so that some messages in it become too long to
read, or (3) a message is missing in NRJECAT.
ACTION: Depending on the reason, (1) check and make sure NRJECAT
exists in NRJE.SYS, (2) make sure no message in the intrinsic,
management, configuration and spooling categories is longer than 72
characters long, or (3) print the
Status array passed to NRJEErrMsg. All
error numbers used in NRJEErrMsg are in Set 1 of NRJECAT.NRJE.SYS.
36 MESSAGE: UNMATCHED INPUT NAME — NO SPOOL FILE HAS BEEN
ALTERED. (INT=36)
CAUSE: No spool file exists whose name matches the one specified in the
ALTER command or NRJEAlter intrinsic.
ACTION: None.
37 MESSAGE: UNMATCHED INPUT NAME — NO SPOOL FILE HAS BEEN
CANCELED. (INT=37)
CAUSE: No spool file exists whose name matches the one specified in the
CANCEL command or NRJECancel intrinsic.
ACTION: None.
38 MESSAGE: UNMATCHED INPUT NAME — NO SPOOL FILE HAS BEEN
FOUND. (INT=38)
CAUSE: No spool file exists whose name matches the one specified in the
SHOW command or NRJEJobInfo intrinsic.
ACTION: None.
39 MESSAGE: LU NOT CONFIGURED. (INT=39)
CAUSE: The LU named was not found in the configuration.
ACTION: Check your spelling or the configuration file.
40 MESSAGE: WSID IS NOT CONFIGURED OR DOES NOT EXIST.
(INT=40)
CAUSE: The
wsid named was not found in the configuration.
ACTION: Check your spelling or the configuration file.
50 MESSAGE: UNABLE TO OPEN NRJEWEL.NRJE.SYS FILE. (INT=50)
CAUSE: File system related error. A file system error message will
appear after this message.
ACTION: Determine the cause by inspecting the file system error
message and correct the problem.