SNA NRJE Node Managers Guide (30292-90007)

Appendix A 137
Result Codes and Messages
SNA NRJE Error Messages
ACTION: Possible configuration error. Check NRJE configuration.
8 MESSAGE: UNABLE TO OBTAIN DEVICE CLASSES FOR THE
READER. (INT=8)
CAUSE: Attempt to obtain device classes for NRJE reader failed.
ACTION: Check
InCount parameter of NRJEQueue and make sure that
InCount is big enough to obtain all device classes; InCount maximum
value is 8.
10 MESSAGE: INPUT NAME LENGTH IS NOT BETWEEN 1 AND 17
CHARACTERS. (INT=10)
CAUSE: Input name length in SHOW, CANCEL, or ALTER command, or
NRJEShow, NRJECancel,orNRJEAlter intrinsic is not between 1 and 17
characters. The input name must be in the form of JobName, @,
SpoolfileId , or UserName.AcctName .
ACTION: Make sure the input name is valid.
12 MESSAGE: NEW PRIORITY FOR SPOOLED FILES IS NOT BETWEEN 0
AND 14. (INT=12)
CAUSE: Input new priority in ALTER command or NRJEAlter intrinsic is
not between 0 and 14.
ACTION: Make sure the new priority is valid.
13 MESSAGE: INPUT NAME IS INVALID. NO SPOOL FILES WERE
CANCELLED. (INT=13)
CAUSE: Input name in CANCEL command or NRJECancel intrinsic is not
valid.
ACTION: Make sure input name is in the form of
JobName , @,
SpoolfileID , or UserName.AcctName .
14 MESSAGE: INPUT NAME IS INVALID. NO SPOOL FILES WERE
ALTERED. (INT=14)
CAUSE: Input name in ALTER command or NRJEAlter intrinsic is not
valid.
ACTION: Make sure input name is in the form of
JobName , @,
SpoolfileID , or UserName.AcctName .
15 MESSAGE: NM CAPABILITY REQUIRED TO ACCESS OTHERS'
SPOOLED FILES. (INT=15)
CAUSE: Attempt to manipulate others’ spooled files failed.
ACTION: Must have NM capability to perform this.