SNA NRJE Node Managers Guide (30292-90007)

Appendix A 133
Result Codes and Messages
Validation Messages
Validation Messages
Listed below are the messages that might occur when you validate the
NRJE configuration data. They are listed in numerical order according
to message number. Configuration file validation is discussed in
Chapter 3 , “SNA NRJE Configuration,” of this manual.
NRJEVALERR 3 MESSAGE: Configuration file corrupt. Missing NRJE path.
(NRJEVALERR 3)
CAUSE: The SNA NRJE path is missing from the configuration file.
ACTION: Create a new configuration file.
NRJEVALERR 4 MESSAGE: Configuration file corrupt. Missing NRJE version.
(NRJEVALERR 4)
CAUSE: No version stamp exists for the SNA NRJE path.
ACTION: Create a new configuration file.
NRJEVALWARN 5 MESSAGE: No configuration data exists for NRJE subsystem.
(NRJEVALWARN 5)
CAUSE: No data is configured for SNA NRJE. Note that this is a
warning message.
ACTION: If you do not want SNA NRJE to be configured, no action is
necessary. If you want NRJE to be configured, you must configure it
before validating the configuration file again.
NRJEVALERR 6 MESSAGE: Path: !
Path name not found. (NRJEVALERR 6)
CAUSE: The indicated path cannot be found in the configuration file.
ACTION: Ensure that the configuration data indicated in the path (for
example,
wised or writername ) is correctly configured. If it is, contact
your HP representative.
NRJEVALERR 7 MESSAGE: Path: !
No data found in path record. (NRJEVALERR 7)
CAUSE: No data is in the record for the indicated path.
ACTION: Ensure that data is configured for the indicated path. If it is,
contact your HP representative.
NRJEVALERR 8 MESSAGE: Path: !
Node “!” is not configured under SNANODE screen. (NRJEVALERR 8)
CAUSE: NA node listed as a configured SNA NRJE node was not
configured as an SNA node.
ACTION: Configure the indicated node as an SNA node on the SNA
Node Configuration screen.