SNA NRJE Node Managers Guide (30292-90007)

126 Chapter6
Commands
WELCOME
WELCOME
Updates the NRJE subsystem welcome message.
Syntax
W[ELCOME]
Description
This command updates the NRJE subsystem welcome message. The
welcome message is broadcast every time any user enters the
subsystem, and when a DISPLAY INFO command is issued. It is not
broadcast when a user invokes the NRJE subsystem command to change
from one default workstation to another.
When you enter this command, NRJE puts you in edit mode with an
nn > prompt at which you can enter a line of the welcome message. For
each welcome message line you enter,
nn is incremented by one.
An
nn > [RETURN] terminates welcome message text input from
sessions. An E0W subcommand terminates welcome message text that is
input from a job stream. The WELCOME command applies to the entire
NRJE subsystem.
A welcome message can be updated as shown in the example below.
NRJE can accept lines of up to 80 characters long, and adds a carriage
control and a line feed at the end of each line. The maximum total
number of characters that can be included in the welcome file is 1920.
This fills the screen of HP 264x and HP 262x terminals. The lines are
stored in image mode and are displayed in the format in which they are
entered.