SNA NRJE Node Managers Guide (30292-90007)

Chapter 6 119
Commands
STOPWS
STOPWS
Stops active LU-LU sessions in an orderly manner.
Syntax
STO[PWS][;W[SID]= Wsid ][;LU= LUName [, LUName ]...]
Parameters
Wsid The workstation name. This can be up to eight
alphanumeric characters long; the first character must
be alphabetic.
If you omit this parameter, the default workstation
identifier is used. You can specify a default workstation
identifier in the NRJE command.
LUName For NRJE/V, this is the name of the SNA node LU class
whose LU-LU sessions you want to stop. (Node classes
are configured on the MPE V SNA Configuration:
Classes screen.) For NRJE/XL, this is the configured LU
Name (not the NAU number) of the LU whose LU-LU
sessions you want to stop. (LUs are configured on the
MPE XL SNANode Configuration: PU and LU Data
screen.)
The name can be up to eight alphanumeric characters
long; the first character must be alphabetic. You can
specify a maximum of five
LUNames . If you do not
specify any
LUNames , all active LUs for that
workstation are stopped.
Description
When the STOPWS command is issued, active LU-LU sessions are
stopped in an orderly manner. This differs from the HALT command,
which causes an immediate termination of the LU-LU sessions. You can
specify a particular workstation by specifying a
Wsid . You can halt all
LU-LU sessions by not specifying any
LUNames , or you can select
sessions to halt by specifying
LUNames . Activities at the workstation can
consist of several LU-LU sessions. All current activities of LU-LU
sessions will continue to completion before stopping. This is called
quiescing. Note that intrinsic tracing for the workstation is not stopped.
NOTE Control is returned to NRJE before completing execution of this
command.