SNA NRJE Node Managers Guide (30292-90007)

Chapter 6 117

Commands

STARTWS

Description

When the STARTWS command is issued, the NRJE monitor is streamed

and runs as an MPE job (see Chapter 4 , “NA NRJE Workstation

Startup and Shutdown,” of this manual). You can start a workstation or

individual LUs.

If you do not specify a

Wsid

, the default workstation identiﬁer is used.

You can specify a default workstation identiﬁer in the NRJE command.

If you do not specify any

LUNames

, all LUs conﬁgured to be initially

started are started. If you specify

LUName

, only those LUs are started.

You also can start intrinsic and/or LU tracing (with the parameter)

with this command. Tracing is described in Chapter 5 , “SNA NRJE

Troubleshooting,” of this manual. Note that LU tracing can be started

for an active workstation only.

NOTE

If an error occurs because of a bad trace parameter, the workstation or

LUs will not start.

Text Reference

See NRJECONTROL START earlier in this chapter. NRJEStartWS is the

manager intrinsic counterpart of this command; it is described in the

SNA NRJE User/Programmer Reference Manual.