SNA NRJE Node Managers Guide (30292-90007)

114 Chapter6
Commands
RELOAD
RELOAD
Causes NRJE to reload the Formid Lookup Table.
Syntax
RELO[AD][;W[SID]= Wsid ]
Parameter
Wsid The workstation name. This can be up to eight
alphanumeric characters long; the first character must
be alphabetic.
If you omit this parameter, the default workstation
identifier is used. You can specify a default workstation
identifier in the NRJE command.
Description
This command causes NRJE to reload the Formid Lookup Table into its
internal copy of the table. The RELOAD command can be used any time
NRJE is active. This command should be used anytime the table is
modified after NRJE is started. A message indicating whether the
reload attempt was successful is logged; the message is not necessarily
sent to the terminal of the user who issued the RELOAD command.
This command is not valid unless the workstation is configured to use
the Formid Lookup Table, in the NRJE Configuration: Workstation
Data Page 2 screen.
Use of the Formid Lookup Table is described in the SNA NRJE
User/Programmer Reference Manual.
Text Reference
See VERIFY later in this chapter for information about verifying the
Formid Lookup Table.