SNA Link/iX Node Managers Guide (30291-90507)

Chapter 3 93
Logging Configuration
Configuring Logging
IBM Logging Configuration (2)
On this screen (Figure 3-4), you specify logging information for these
subsystems: APPC, link trace, and SDLC link.
If you want to specify logging information for an SNA subsystem not
shown on this screen, press
[f1] (Next Screen), which places you at the
“IBM Logging Configuration (3)” screen (described later in this
chapter), or press
[f8] (Prior Screen), which places you at the “IBM
Logging Configuration (1)” screen (described earlier in this chapter).
Figure 3-4 IBM Logging Configuration (2) Screen
Fields Subsystem
For display only. The names and numbers of the
subsystems you can configure logging for on this screen.
Class Name
For display only. The names of the logging classes
you can configure logging for on this screen.
Console Logging
Required. Enter Y if you want logging events for a
class displayed at the HP e3000 console; N, otherwise.
Refer to Table 3-1 for guidelines.
Default: Each class’s default is the recommended
setting for that class (see Table 3-1).