SNA Link/iX Node Managers Guide (30291-90507)

76 Chapter2

SNA Node and Link Conﬁguration

Conﬁguring the SNA Node and Link

Figure 2-9 PVC Conﬁguration Dependencies

For an SNA/X.25 SVC:

• “Network Interface Conﬁguration” screen: The Configured

Network Interfaces list must include the NI name speciﬁed for NS

Network Interface Name on the screen shown in Figure 2-8, “X.25

Link Data Screen.”.

• “X.25 SVC Address Key Paths” screen: The name of the facility set

conﬁgured for the SVC must be found on this screen, even though it

is not actually used in the SNA/X.25 conﬁguration.

— If you reserve the facility set for the SNA/X.25 SVC’s use only, the

X.25 Address you specify for the facility set on this screen must

match the address you specify for Remote’s X.25 Network

Address on the screen shown in Figure 2-8, “X.25 Link Data

Screen.” Note that this address is the remote system’s address.

Also, the security speciﬁcation in the “X.25 SVC Address Key

Paths” screen must be compatible with the Call Direction

speciﬁed on the screen shown in Figure 2-8, “X.25 Link Data

Screen.”

— If you do not reserve the facility set for SNA/X.25’s use, by

associating it with the remote system’s address, you must

conﬁgure it as the POOL facility set. You do this by specifying the

facility set as the default facility set for the POOL X.25 address