SNA Link/iX Node Managers Guide (30291-90507)

70 Chapter2
SNA Node and Link Configuration
Configuring the SNA Node and Link
X.25 Link Data Screen
Once you have specified the PU and LU information, you are ready to
configure the communications link parameters and virtual circuit data
for the X.25 link. You do this on the screen shown in Figure 2-8, “X.25
Link Data Screen.” Select this screen by pressing
[f1] (Go To LINKDATA)
on the screen shown in Figure 2-4, “PU Data Screen.” (You can go
directly to this screen from any screen by typing
@SNANODE.
nodename .X25LINK in the command window and pressing
[ENTER].)
Figure 2-8 X.25 Link Data Screen
Fields Path:
For display only. The NMMGR path to this screen. It
includes the name of the SNA node you are configuring.
NS Network Interface Name
Required. The NS network interface that the X.25 link
will use. The name can be up to eight alphanumeric
characters long; the first character must be alphabetic.
See the appropriate NS documentation for more
information.
X.25 System Access Configuration: An NI name in the
Configured Network Interfaces field of the
“Network Interface Configuration” screen must match
this field.