SNA Link/iX Node Managers Guide (30291-90507)

Appendix A 245
Messages
X.25 Link Module Configurator Error Codes
X.25 Link Module Configurator Error Codes
Listed below are the error codes that are generated by the X.25 link
module configurator. These messages are displayed on the HP e3000
operator's console. They are listed here in numerical order according to
the
ErrorCode displayed as part of these SNA Transport logging
messages:
Attempt to close link failed on node NodeName
Subsystem = 734, Error Code = ErrorCode
Attempt to open link failed on node NodeName
Subsystem = 734, Error Code = ErrorCode
The logging messages are described in “SNA Transport Logging
Messages” earlier in this appendix.
-200 MESSAGE: CONFIG OPEN ERROR
CAUSE: The module configurator encountered an error while trying to
open the configuration file.
ACTION: Verify that the NMCONFIG.PUB.SYS configuration file exists.
-201 MESSAGE: CONFIG RETRIEVAL ERROR
CAUSE: The module configurator encountered an error while retrieving
the SNA/X.25 link configuration information for the current SNA node.
ACTION: Verify that the correct version of NMMGR is installed on the
system, and that an X.25 link is configured for the SNA node being
started.
-202 MESSAGE: PROCESS CREATION ERROR
CAUSE: The module configurator was unable to launch the Qualified
Logical Link Control (QLLC) module.
ACTION: Verify that the file containing the QLLC module
(SNAX25.PUB.SYS) exists.
-203 MESSAGE: TRACE OPEN ERROR
CAUSE: The module configurator was unable to open the trace file.
ACTION: Issue the SNACONTROL START command with the trace file
name specified for the
LINKTRACE parameter. If the error still occurs,
issue the SNACONTROL START command
without specifying a trace file
name (that is, let the default file name be used). If the error still occurs,
call your Hewlett-Packard support contact.
-204 MESSAGE: STATUS BUFFER INVALID
CAUSE: The Qualified Logical Link Control (QLLC) module returned an
invalid buffer containing the link status information. Note that the