SNA Link/iX Node Managers Guide (30291-90507)

Appendix A 217
Messages
SNACONTROL Error Messages
SNACIERR 105 MESSAGE: CAN’T SPECIFY LFSID HERE. (SNACIERR 105)
CAUSE:
LFSID was specified as a parameter to an SNACONTROL command
other than SNACONTROL STATUS. Only SNACONTROL STATUS permits this
parameter.
ACTION: Don’t specify
LFSID as a parameter to any SNACONTROL
command except SNACONTROL STATUS.
SNACIERR 106 MESSAGE: CAN’T SPECIFY NAU HERE. (SNACIERR 106)
CAUSE:
NAU was specified as a parameter to an SNACONTROL command
other than SNACONTROL STATUS. Only SNACONTROL STATUS permits this
parameter.
ACTION: Don’t specify
NAU as a parameter to any SNACONTROL command
except SNACONTROL STATUS.
SNACIERR 107 MESSAGE: CAN’T SPECIFY STATE HERE. (SNACIERR 107)
CAUSE:
STATE was specified as a parameter to an SNACONTROL command
other SNACONTROL STATUS. Only SNACONTROL STATUS permits this
parameter.
ACTION: Don’t specify
STATE as a parameter to any SNACONTROL
command except SNACONTROL STATUS.
SNACIERR 108 MESSAGE: CAN’T SPECIFY SESSTYPE HERE. (SNACIERR 108)
CAUSE:
SESSTYPE was specified as a parameter to an SNACONTROL
command other than SNACONTROL STATUS. Only SNACONTROL STATUS
permits this parameter.
ACTION: Don’t specify
SESSTYPE as a parameter to any SNACONTROL
command except SNACONTROL STATUS.
SNACIERR 109 MESSAGE: BAD NAU SPECIFICATION. (SNACIERR 109)
CAUSE: A non-integer value was specified in the
NAU= parameter.
ACTION: The
NAU= parameter must be an integer.
SNACIERR 110 MESSAGE: BAD LFSID SPECIFICATION. (SNACIERR 110)
CAUSE: A non-hex value was specified in the
LFSID= parameter.
ACTION: The
LFSID= parameter must be a hex value.
SNACIERR 111 MESSAGE: NAU NOT FOUND. (SNACIERR 111)
CAUSE: The
NAU specified in the SNACONTROL STATUS command does not
exist.
ACTION: The NAU= parameter must specify an existing NAU.
SNACIERR 112 MESSAGE: LFSID NOT FOUND. (SNACIERR 112)
CAUSE: The
LFSID specified in the SNACONTROL STATUS command does
not exist.