SNA Link/iX Node Managers Guide (30291-90507)

Appendix A 193
Messages
SDLC Link Driver Error Messages
1039 MESSAGE: Unable to release a buffer manager buffer.
CAUSE: The driver tried to free memory that the buffer manager did not
recognize as a valid buffer because of a driver problem or memory data
corruption. Also, a problem somewhere might have caused the driver to
try to free a buffer that was not in use
ACTION: A system dump will probably be required. Call your
Hewlett-Packard support contact.
1040 MESSAGE: Unable to obtain an I/O Services timer.
CAUSE: A call to obtain a timer resource returned in error. Too many
timers might be in use.
ACTION: If you suspect your system might be low on timer resources
because of heavy loading, try restarting the link later. If repeated
attempts fail, try warmstarting your system. If the problem continues,
a system dump will be required. Call your Hewlett-Packard support
contact.
1041 MESSAGE: Unable to reset an I/O Services timer.
CAUSE: The system rejected an attempt by the driver to reset a timer
supposedly owned by the driver. Memory data corruption might have
occurred.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard support contact.
1042 MESSAGE: Unable to release an I/O Services timer.
CAUSE: The driver tried to free a timer that was not recognized by the
system as a valid timer. Memory data corruption might have occurred.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard support contact.
1043 MESSAGE: Unable to obtain an I/O Services message frame.
CAUSE: The driver could not obtain a reply message frame from the
source port of a newly-arrived request message, or from a transport
port in the case of a driver-detected asynchronous event. If the system
is operating well otherwise, modules trying to communicate with the
driver might not be operating with the required capabilities.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard support contact.
1044 MESSAGE: Unable to send an I/O Services message to another
process.
CAUSE: A call to the system message send routine returned in error.
The destination port might belong to a process that no longer exists or
is not operating with the required capabilities.
ACTION: Write down the error information displayed on the console,