SNA Link/iX Node Managers Guide (30291-90507)

184 AppendixA
Messages
SDLC Link Startup Error Messages
18 MESSAGE: Unable to obtain dump/diag ports.
CAUSE: The Diagnostic User Interface (DUI) software or the Network
Dump Process was not installed properly.
ACTION: Write down the error information displayed on the console and
call your Hewlett-Packard support contact.
19 MESSAGE: Could not create the auxiliary buffer pool.
CAUSE: An internal error has occurred.
ACTION: Write down the error information displayed on the console and
call your Hewlett-Packard support contact.
20 MESSAGE: Could not create or bind with the driver.
CAUSE: (
Status = C3 xx 00D8) The wrong path number is configured for
the installed PSI card.
ACTION: Use NMMGR to correct the Physical Path for the link.
CAUSE: (
Status = CD xx 00D5) The card for the configured path number
is bad.
ACTION: Use NMMGR or the configuration file critical summary to
check that the Physical Path configured for the link corresponds to a
good PSI card. To determine whether the PSI card is good, your
Hewlett-Packard support contact will have to run diagnostics on the
PSI.
CAUSE: (
Status = DA xx 00D5) No card is in the slot for the path number
configured for the link.
ACTION: Use NMMGR or the configuration file critical summary to
check the configured Physical Path for the link, and correct it if
necessary. Or, call your Hewlett-Packard support contact to install a
PSI card.
CAUSE: (
Status = E0 xx 00D5) The bus converter is not configured.
ACTION: Your local Hewlett-Packard support contact will have to check
the bus converter configuration in SYSGEN and reconfigure it, if
necessary (for Series 950 only).
CAUSE: ( Status = FA xx 00D8) The I/O subsystem still has the card
configured and marked active.
ACTION: First, try shutting down the link. If the problem continues,
restart the system. If this does not correct the problem, write down the
error information displayed on the console and call your
Hewlett-Packard support contact.
21 MESSAGE: Could not add the link name to the link table.
CAUSE: Another link with the same name has already started.
ACTION: Try shutting down the link and starting it up again.