SNA Link/iX Node Managers Guide (30291-90507)

Chapter 6 159
MPE Commands
SNACONTROL STATUS
without success. Note that this information is displayed for an outgoing
SVC only.
The call retry delay is the number of seconds the QLLC module will
wait between attempts to connect to the remote system. Note that this
information is displayed for an outgoing SVC only.
The call retry count is the number of times call retries have been
attempted. Note that this information is displayed for an outgoing SVC
only.
Total bytes is the total number of bytes sent from and received by the
link.
Data bytes is the total number of bytes of data sent from and received
by the link.
Control bytes is the total number of bytes of control information sent
from and received by the link.
Total packets is the total number of packets sent from and received by
the link.
Data packets is the total number of packets of data sent from and
received by the link.
Control packets is the total number of packets of control information
sent from and received by the link.
Token Ring Link-Level Status Information
An example of a Token Ring link-level status display is given below, and
the terminology used is described after the example. Note that when
link-level status information is displayed, the corresponding
session-level status information is also displayed. (Since the
session-level status terminology is described later under “Session-Level
Status Information,” it is not described here.)
Example If a Token Ring link is being used, typing
SNACONTROL STATUS;NODE=IBMNODE;LINK=ALL