SNA Link/iX Node Managers Guide (30291-90507)

Chapter 6 139
MPE Commands
SHOWNMLOG
SHOWNMLOG
Displays the identification number and available space of the NM log
file.
Syntax
SHOWNMLOG
Use
SHOWNNMLOG can be issued from a session, a job, a program, or in break.
Pressing
[BREAK] has no effect on this command.
Description
SHOWNMLOG displays the number of the current NM log file
(NMLG
nnnn .PUB.SYS) and the percentage of available file space
currently used. The information is displayed in this format:
NMLG FILE NUMBER nnnn IS mm % FULL
where
nnnn is the NM log file number and mm is the percentage of file
space used.
If an irrecoverable error has disabled NM logging, this message is
displayed instead of the command's normal display:
NMLG FILE NUMBER nnnn ERROR # nn .
NM LOGGING STOPPED. (NMCNERR 36)
You will have to do a warm or cool start to bring the system back up.
If NM logging is enabled but currently suspended because of a
recoverable error, an explanatory message is displayed after the
command’s normal display:
NMLG FILE NUMBER nnnn IS mm % FULL
NMLG FILE NUMBER nnnn ERROR # mm . NM LOGGING SUSPENDED.
(NMCN ERR 38)
Once the error is corrected, you can issue the RESUMENMLOG command
(described earlier in this chapter).