SNA Link/iX Node Managers Guide (30291-90009)

96 Chapter3
Logging Configuration
Configuring Logging
Configuration (3)” screen, the value on the other screen
is overridden by the value you enter here.
Default: Y
NOTE If you change the disk logging configuration for a subsystem, the
changes will not take effect until
that subsystem is shut down and
restarted.
Current number of users enabled for logging
For display only. The number of users specified for
Users enabled for logging. For example, if two
users are specified for Users enabled for logging,
the value 2 would be displayed here when
[f6] (Save
Data) is pressed.
Users enabled for logging
You can have the logging events for
only this
subsystem and class
displayed at the list devices of
users. We recommend that you enable logging for the
users responsible for installing and maintaining the
SNA subsystems you are configuring logging for. Enter
up to three user names in the form
UserName.AccountName . When you press [f6] (Save
Data), NMMGR deletes duplicate entries and enters
the number of users specified into Current number of
users enabled for logging.
NOTE If a user enabled for logging is logged on at the system console, and
console logging is enabled, two copies of each logged message might be
received.
File
For display only. The name of the configuration file.
Once you have entered the data, press
[f6] (Save Data).
After the information is saved, press
[f8] (Prior
Screen) until you get to the screen you need next.