SNA Link/iX Node Managers Guide (30291-90009)

92 Chapter3
Logging Configuration
Configuring Logging
Figure 3-5 IBM Logging Configuration (3) Screen Example
Fields
Subsystem For display only. The names and numbers of the
subsystems you can configure logging for on this screen.
Class Name For display only. The names of the logging classes
you can configure logging for on this screen.
Console Logging Required. Enter Y if you want logging events for a
class displayed at the HP 3000 console; N, otherwise.
Refer to Table 3-1 for guidelines.
Default: Each class’s default is the recommended
setting for that class (see Table 3-1).
NOTE If you change the console logging configuration for any subsystem, the
changes will not take effect until the
entire HP 3000 system is shut
down and restarted.
Disk Logging Required. Enter Y if you want logging events for a
class recorded in the NM log file; N, otherwise. The file
name that Node Management Services (NMS) uses is
NMLG
nnnn .PUB.SYS, where nnnn is a number from 0000
through 9999 . This is a common file used for logging by
all logging classes in all subsystems. At each MPE
system startup, or when a file is full, NMS creates a
new NMLG
nnnn .PUB.SYS file, naming each successive