SNA Link/iX Node Managers Guide (30291-90009)

Appendix A 219
Messages
SNA Transport Error Messages
SNAERR 51 MESSAGE: Link Failure occurred. (SNAERR 51)
CAUSE: A link failure has occurred, and all sessions are being notified.
ACTION: Wait until the node has been reactivated and then try again.
SNAERR 52 MESSAGE: SNA Transport Internal Error Shutdown. (SNAERR 52)
CAUSE: An SNA Transport internal error has occurred, and all sessions
are being notified.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.
SNAERR 55 MESSAGE: Bad Maxinfo length parameter. (SNAERR 55)
CAUSE: An invalid
MaxInfolgth parameter was specified in a call to the
SNASessinfo intrinsic.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.
SNAERR 58 MESSAGE: Error msg truncated because buffer was too small.
(SNAERR 58)
CAUSE: A buffer too small to hold the error message from the SNA
Transport message catalog file (CATSNA.PUB.SYS) was passed in a call
to the HPSNAErrmsg or SNAErrmsg intrinsic.The message was truncated
to fit into the buffer that was passed.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.
SNAERR 100 MESSAGE: Expedited response pending. (SNAERR 100)
CAUSE: An attempt to send an expedited request was made while in a
state that does not allow it.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.
SNAERR 101 MESSAGE: Data traffic inactive. (SNAERR 101)
CAUSE: An attempt to send a request was made before a Start Data
Traffic (SDT) has been received or the positive response has been sent.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.
SNAERR 102 MESSAGE: SDT request not received. (SNAERR 102)
CAUSE: A response to a Start Data Traffic (SDT) is being sent, but no
SDT was received from the remote system.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.