SNA Link/iX Node Managers Guide (30291-90009)
Table Of Contents
- 1 SNA Links Overview
- 2 SNA Node and Link Configuration
- 3 Logging Configuration
- 4 SNA Node Startup and Shutdown
- 5 SNA Link Troubleshooting
- 6 MPE Commands
- 7 SNA Link Installation Information
- A Messages
- SDLC Link Startup Error Messages
- SDLC Link Driver Error Messages
- SNACONTROL Error Messages
- SNA Transport Error Messages
- SNA Transport Logging Messages
- SDLC Link Shutdown Error Messages
- X.25 Link Failure Error Codes
- X.25 Link Module Configurator Error Codes
- X.25 Link QLLC Internal Error Codes
- NetView Alerts Error Messages
- Network Dump Manager Error Messages
- LAN Error Messages
- B Netview Alerts

218 AppendixA
Messages
SNA Transport Error Messages
SNAERR 36 MESSAGE: Link shutdown occurred. (SNAERR 36)
CAUSE: A link shutdown has been requested with the SNACONTROL STOP
command, and all sessions are being notified.
ACTION: Wait until the link has been restarted and then continue.
SNAERR 37 MESSAGE: Protocol shutdown requested. (SNAERR 37)
CAUSE: A protocol shutdown has been requested with the SNACONTROL
STOP command, and all sessions are being notified.
ACTION: Wait until the link has been restarted and then continue.
CAUSE: A protocol shutdown has been requested with the SNACONTROL
STOPSESS command, and the session it was requested for is being
notified.
ACTION: None.
SNAERR 38 MESSAGE: Quiesce shutdown requested. (SNAERR 38)
CAUSE: A quiesce shutdown has been requested with the SNACONTROL
STOP command. New sessions will not be started, and all current active
sessions are to complete their current activities and close in an orderly
fashion.
ACTION: Wait until the link has been restarted and then continue.
CAUSE: A quiesce shutdown has been requested with the SNACONTROL
STOPSESS command, and the session it was requested for is being closed
in an orderly fashion.
ACTION: None.
SNAERR 39 MESSAGE: CATSNA.PUB.SYS access error. (SNAERR 39) SNA
Transport was unable to access its catalog file.
CAUSE: The SNA Transport message catalog file (CATSNA.PUB.SYS) is
missing, invalid, or locked by another process.
ACTION: Replace the catalog file with a valid SNA catalog file.
SNAERR 40 MESSAGE: Out of Stack Space. (SNAERR 40)
CAUSE: A call was made to an SNA Transport intrinsic without enough
stack space available or with the data segment frozen in memory.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.
SNAERR 48 MESSAGE: Invalid data offset. (SNAERR 48)
CAUSE: An invalid offset into the given data segment was specified in a
call to an SNA Transport intrinsic.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.