SNA Link/iX Node Managers Guide (30291-90009)

212 AppendixA
Messages
SNACONTROL Error Messages
ACTION: The LFSID= parameter must specify an existing LFSID.
SNACIERR 113 MESSAGE: BAD LUNAME SPECIFICATION. (SNACIERR 113)
CAUSE: A bad
LUNAME was specified in the LUNAME= parameter.
ACTION: Verify that the
LUNAME= parameter was valid.
SNACIERR 114 MESSAGE: NO SUCH SESSIONS FOUND. (SNACIERR 114)
CAUSE: No sessions were found that match the given
STATE= and
SESSTYPE= parameters.
ACTION: None. This is a normal event.
SNACIERR 115 MESSAGE: BAD TOKEN RING LINK NAME. (SNACIERR 115)
CAUSE: Link name specified in the SNA NODE configuration is not
valid.
ACTION: Change LINKNAME to a valid link name.
SNACIERR 116 MESSAGE: SNA TOKEN RING NOT INSTALLED PROPERLY.
(SNACIERR 116)
CAUSE: SNA TOKEN RING not installed.
ACTION: Call your Hewlett-Packard contact.
SNACIERR 117 MESSAGE: SNA SDLC NOT INSTALLED PROPERLY. (SNACIERR 117)
CAUSE: SNA SDLC LINK not installed.
ACTION: Call your Hewlett-Packard contact.