SNA Link/iX Node Managers Guide (30291-90009)

204 AppendixA
Messages
SNACONTROL Error Messages
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.
SNACIERR 51 MESSAGE: CAN’T SPECIFY LUNAME HERE. (SNACIERR 51)
CAUSE: The
LUName parameter was specified in an SNACONTROL
AUTODIAL, SNACONTROL START, SNACONTROL STOP, or SNACONTROL
VERSION command. None of these commands uses
LUName .
ACTION: Reissue the command without an
LUName parameter.
SNACIERR 52 MESSAGE: CAN’T SPECIFY LINKTRACE HERE. (SNACIERR 52)
CAUSE: The
LINKTRACE parameter was specified in an SNACONTROL
AUTODIAL, SNACONTROL STATUS, SNACONTROL STOP, SNACONTROL
STOPSESS,orSNACONTROL VERSION command. None of these commands
uses
LINKTRACE .
ACTION: Reissue the command without a
LINKTRACE parameter.
SNACIERR 53 MESSAGE: CAN’T SPECIFY NODETRACE HERE. (SNACIERR 53)
CAUSE: The
NODETRACE parameter was specified in an SNACONTROL
AUTODIAL, SNACONTROL STATUS, SNACONTROL STOP, SNACONTROL
STOPSESS, SNACONTROL TRACEOFF, SNACONTROL TRACEON, or
SNACONTROL VERSION command. None of these commands uses
NODETRACE .
ACTION: Reissue the command without a
NODETRACE parameter.
SNACIERR 54 MESSAGE: CAN’T SPECIFY INTRINSIC HERE. (SNACIERR 54)
CAUSE: The
INTRINSIC parameter was specified in an SNACONTROL
AUTODIAL, SNACONTROL START, SNACONTROL STATUS, SNACONTROL
STOP, SNACONTROL STOPSESS,orSNACONTROL VERSION command. None
of these commands uses
INTRINSIC .
ACTION: Reissue the command without an
INTRINSIC parameter.
SNACIERR 55 MESSAGE: TRACE COMMAND IGNORED. PLEASE SPECIFY TRACE
TYPE. (SNACIERR 55)
CAUSE: The SNACONTROL TRACEOFF or SNACONTROL TRACEON command
was issued, but a valid trace type was not specified.
ACTION: Reissue the command with the
LINKTRACE or INTRINSIC
parameters.
SNACIERR 59 MESSAGE: CAN’T SPECIFY “LINK” HERE. (SNACIERR 59)
CAUSE: The
LINK parameter was specified in an SNACONTROL AUTODIAL,
SNACONTROL START, SNACONTROL STOP, SNACONTROL STOPSESS,
SNACONTROL TRACEOFF, SNACONTROL TRACEON,orSNACONTROL VERSION
command. None of these commands uses
LINK .
ACTION: Reissue the command without a
LINK parameter.