SNA Link/iX Node Managers Guide (30291-90009)

Table Of Contents
Appendix A 181
Messages
SDLC Link Driver Error Messages
CAUSE: The host system is transmitting data before the HP 3000 sends
a final bit in its frame to relinquish control of the line.
ACTION: Run the SNACONTROL STATUS command, and check the Frames
Retransmitted value in the link-level status information (see Chapter
6 , “MPE Commands,” of this manual). If the value is
not
zero, ensure
that the REPLYTO operand of the GROUP macro in the IBM host’s
ACF/NCP generation is large enough to account for all network delays
1003 MESSAGE: An unknown interrupt type was received from
IO_Services.
CAUSE: Unknown.
ACTION: Write down the error information displayed on the console,
submit an SR, and call your Hewlett-Packard support contact.
1004 MESSAGE: PSI fatal error, dinmode.
CAUSE: The download file PSISDLC0.PUB.SYS or PSISDLC1.PUB.SYS is
corrupt.
ACTION: Replace the download file from your latest system update tape.
CAUSE: Bad PSI hardware.
ACTION: Your Hewlett-Packard support contact will have to run
diagnostics on the PSI.
1005 MESSAGE: PSI fatal bus error.
CAUSE: The download file PSISDLC0.PUB.SYS or PSISDLC1.PUB.SYS is
corrupt.
ACTION: Replace the download file from your latest system update tape.
CAUSE: Bad PSI hardware.
ACTION: Your Hewlett-Packard support contact will have to run
diagnostics on the PSI.
1006 MESSAGE: PSI fatal internal error.
CAUSE: The download file PSISDLC0.PUB.SYS or PSISDLC1.PUB.SYS is
corrupt.
ACTION: Replace the download file from your latest system update tape.
CAUSE: Bad PSI hardware.
ACTION: Your Hewlett-Packard support contact will have to run
diagnostics on the PSI.
1007 MESSAGE: PSI fatal internal error.
CAUSE: The download file PSISDLC0.PUB.SYS or PSISDLC1.PUB.SYS is
corrupt.
ACTION: Replace the download file from your latest system update tape.