SNA Link/iX Node Managers Guide (30291-90009)
Table Of Contents
- 1 SNA Links Overview
- 2 SNA Node and Link Configuration
- 3 Logging Configuration
- 4 SNA Node Startup and Shutdown
- 5 SNA Link Troubleshooting
- 6 MPE Commands
- 7 SNA Link Installation Information
- A Messages
- SDLC Link Startup Error Messages
- SDLC Link Driver Error Messages
- SNACONTROL Error Messages
- SNA Transport Error Messages
- SNA Transport Logging Messages
- SDLC Link Shutdown Error Messages
- X.25 Link Failure Error Codes
- X.25 Link Module Configurator Error Codes
- X.25 Link QLLC Internal Error Codes
- NetView Alerts Error Messages
- Network Dump Manager Error Messages
- LAN Error Messages
- B Netview Alerts
Chapter 6 167
MPE Commands
SNACONTROL VERSION
SNACONTROL VERSION
Identifies the software version of SNA Transport, SNA/X.25 Link, and
SNA/Token Ring Link.
Syntax
SNACONTROL VERSION
Use
SNACONTROL VERSION can be issued from a session, a job, a program, or
in break. Pressing
[BREAK] has no effect on this command.
Description
SNACONTROL VERSION identifies versions of SNA Transport program
files, NL procedures, and SL procedures, as well as the overall version.
It also identifies versions of the SNA/X.25 Link program file and NL
procedures, as well as the overall version. Version ID numbers include
version, update, and fix levels (
v.uu.ff
), as well as an internal fix level.
For example, the version ID number A0102111 represents version
level A, update level 01, fix level 02, and internal fix level 111. Ignore
the internal fix level; this is used only within Hewlett-Packard.
Output from SNACONTROL VERSION is sent to $STDLIST.