SNA Link/iX Node Managers Guide (30291-90009)
Table Of Contents
- 1 SNA Links Overview
- 2 SNA Node and Link Configuration
- 3 Logging Configuration
- 4 SNA Node Startup and Shutdown
- 5 SNA Link Troubleshooting
- 6 MPE Commands
- 7 SNA Link Installation Information
- A Messages
- SDLC Link Startup Error Messages
- SDLC Link Driver Error Messages
- SNACONTROL Error Messages
- SNA Transport Error Messages
- SNA Transport Logging Messages
- SDLC Link Shutdown Error Messages
- X.25 Link Failure Error Codes
- X.25 Link Module Configurator Error Codes
- X.25 Link QLLC Internal Error Codes
- NetView Alerts Error Messages
- Network Dump Manager Error Messages
- LAN Error Messages
- B Netview Alerts
Chapter 6 161
MPE Commands
SNACONTROL STOPSESS
• Q = (Quiesce) The session is stopped in an orderly
way. SNA Transport notifies the SNA services that it
is stopping the specified LU. Each service completes
sending and receiving all active data sets in the
LU-LU session. Once the session is stopped, a
logging message specifying that the LU-LU session
has terminated is generated.
Default: Q
Description
SNACONTROL STOPSESS stops an LU-LU session without stopping the
SNA node. Only an LU-LU session can be stopped with this command.
NOTE
SNACONTROL STOPSESS will not terminate a “hung session.”
Example SNACONTROL STOPSESS;NODE=ALPHA;LUNAME=LU1
The LU-LU session for LU1 on node ALPHA is to be stopped in an
orderly way (a quiesce). A quiesce is done because no
StopType
was
specified.