SNA Link/iX Node Managers Guide (30291-90009)
Table Of Contents
- 1 SNA Links Overview
- 2 SNA Node and Link Configuration
- 3 Logging Configuration
- 4 SNA Node Startup and Shutdown
- 5 SNA Link Troubleshooting
- 6 MPE Commands
- 7 SNA Link Installation Information
- A Messages
- SDLC Link Startup Error Messages
- SDLC Link Driver Error Messages
- SNACONTROL Error Messages
- SNA Transport Error Messages
- SNA Transport Logging Messages
- SDLC Link Shutdown Error Messages
- X.25 Link Failure Error Codes
- X.25 Link Module Configurator Error Codes
- X.25 Link QLLC Internal Error Codes
- NetView Alerts Error Messages
- Network Dump Manager Error Messages
- LAN Error Messages
- B Netview Alerts
140 Chapter6
MPE Commands
SNACONTROL STATUS
LUName
The name of the LU whose session status you want
displayed. The name can be up to eight alphanumeric
characters long. The first character must be alphabetic.
If this parameter is specified, neither the
NAU
nor
LFSID
parameters can be specified. Specifying this parameter
without an LU name causes the sessions to be
displayed in alphabetical order.
NAU
The NAU number of the dependent session whose
status you want to display. The NAU number must be a
decimal number between 0 and 255. If this parameter
is specified, neither the
LUNAME
nor
LFSID
parameters
can be specified. Specifying this parameter without an
NAU number causes the sessions to be displayed in
numerical order.
LFSID
The LFSID number of the independent session whose
status you want to display. The LFSID must consist of
the ODAI followed by the SID, with a comma as a
separator. The ODAI must be either 0 or 1. The SID
must be a hex number between $0000 and $FFFE. If
this parameter is specified, neither the
LUNAME
nor
NAU
parameters can be specified. Specifying this parameter
without an LFSID number causes the sessions to be
displayed in numerical order.
STATUS
Specifies the status of the sessions that are to be
displayed. Possible values for this parameter are ALL
(all sessions), ACTIVE (only active sessions), INACTIVE
(only inactive sessions), PENDING (only sessions that are
pending activation or pending reset), and RESET (only
reset sessions).
SESSTYPE
Specifies the session type of the sessions that are to be
displayed. Possible values for this parameter are ALL
(all sessions), SSCP (only PU-SSCP and LU-SSCP
sessions), LU (only LU-LU dependent and LU-LU
independent sessions), LU_DEP (only LU-LU dependent
sessions), and LU_IND (only LU-LU dependent
sessions).
NCB
Specifies that the node’s Node Control Block (NCB) is to
be displayed. This parameter is for Hewlett-Packard
debugging purposes, and should be used only under HP
recommendation.
HSCB
Specifies that the session’s Half Session Control Block
(HSCB) is to be displayed.
This parameter is for Hewlett-Packard debugging
purposes, and should be used only under HP
recommendation.