SNA Link/iX Node Managers Guide (30291-90009)

Chapter 6 131
MPE Commands
6 MPE Commands
This chapter describes, in alphabetical order, the MPE commands
related to SNA Transport. You must have MPE node manager (NM)
capability to use these commands. Table 6-1 summarizes the functions
of the commands.
Table 6-1 MPE Command Summary
Command Function
RESUMENMLOG Resumes NM logging after a recoverable
error.
SHOWNMLOG Displays the identification number and
available space of the NM log file.
SNACONTROL AUTODIAL Causes an SNA node's auto-dial modem to
dial.
SNACONTROL START Starts an SNA node, link-level tracing, and
SNA Transport node tracing.
SNACONTROL STATUS Displays the status of a specific SNA node.
SNACONTROL STOP Stops an SNA node and all activity on the
node.
SNACONTROL STOPSESS Stops an LU-LU session without stopping
the SNA node.
SNACONTROL TRACEOFF Turns off link-level tracing, SNA Transport
intrinsic tracing, and SNA Transport node
tracing.
SNACONTROL TRACEON Turns on link-level tracing, SNA Transport
intrinsic tracing, and SNA Transport node
tracing.
SNACONTROL VERSION Identifies the software version of SNA
Transport, SNA/X.25 Link, and SNA/Token
Ring Link.
SWITCHNMLOG Closes the current NM log file and creates
and opens a new one.