Read Before Installing MPE/iX Release 7.0 (C.70.00) (30216-90313)

Chapter 1 11
Information You Need Before Installing MPE/iX 7.0
Modem Connections on A- and N-Class
Modem Connections on A- and N-Class
The modem that is supported on the Remote console port on the N-Class and A-Class
systems is the MultiTech Model MT5634ZBA (HP part No: 0960-1074).
The physical connection is:
The cable is connected to the 9 pin Remote Console Serial port on the core I/O card.
Connect the modem to the system and to the phone line. Make sure the modem is
connected to the AC power and is turned on. There is a small switch on the side of the
modem.
The following is the dialog to verify and configure the modem:
==============================================
GSP Host Name: <systemname>
GSP> CA
CA
===================================
This command allows you to modify the local and remote modem serial port configurations.
Current configuration settings:
Local Console Serial Port bit rate: 9600 bits/s
Local Console Serial Port Flow Control: Software
Local Console Serial Port Terminal Type: hpterm
Remote Console Serial Port Modem Protocol: CCITT
Remote Console Serial Port Modem bit rate: 19200 bits/s
Remote Console Serial Port Modem Flow Control: Software
Remote Console Serial Port Modem Transmit Configuration Strings: Enabled
Remote Console Serial Port Modem Presence: always connected
Do you want to modify the Local Console Serial Port settings? (Y/[N])
Do you want to modify the Remote Console Serial Port Modem settings? (Y/[N])
===================================
Modem
console
port
24542M
or cable that
comes with modem
N-Class/A-Class
Remote