NS3000/iX Operations and Maintenance Reference Manual (36922-90042)

166 Chapter7
Commands
NSCONTROL STATUS
Example 4
In the following example, the Network Services have not been started
(no NSCONTROL START has not been issued). The system response to the
NSCONTROL STATUS=USERS,SERVICES command shows that there are
no Network Services users and no Network Services currently active.
:NSCONTROL STATUS=USERS,SERVICES
NO CURRENT NETWORK SERVICE USERS
NO NETWORK SERVICES ARE CURRENTLY ACTIVE
Example 5
Example 5 shows the brief summary of users, services, and servers
information. This is an abbreviated display of STATUS=ALL.
:NSCONTROL STATUS=SUMMARY
TOTAL NUMBER OF LOCAL NS USERS: 1
TOTAL NUMBER OF REMOTE NS USERS: 0
TOTAL NUMBER OF NS USERS: 1
OUTGOING SERVICES INCOMING SERVICES
SERVICE STARTED FEATURES SERVICE STARTED FEATURES
NSSTATL YES VTA YES
RPML YES NSSTAT YES
PTOPL YES LOOPBACK YES
RFAL YES RPM YES AUTOLOGON OFF
NFTL YES PTOP YES
VTRL YES RFA YES AUTOLOGON ON
VTL YES NFT YES AUTOLOGON ON
VTR YES
VT YES
SERVER MIN MAX ACTIVE RESERVED DEBUG
RASERVER 0 300 0 0 OFF
NSSTATUS 0 300 0 0 OFF
LOOPBACK 0 300 0 0 OFF
VTSERVER 6 300 1 5 OFF
NFT 0 300 0 0 OFF
DSSERVER 0 300 0 0 OFF
TOTAL NUMBER OF ACTIVE SERVERS: 1
TOTAL NUMBER OF RESERVED SERVERS: 5
TOTAL NUMBER OF SERVERS: 6