NS3000/iX Operations and Maintenance Reference Manual (36922-90042)

164 Chapter7
Commands
NSCONTROL STATUS
Example 1
The following example shows the status of the Network Services. Local
means the service gives local users access to remote resources; remote
means the service gives remote users access to local resources. Server
indicates the type of server, NFT or DSSERVER, used for the service. For
this example, all the services were started as indicated by YES in the
STARTED column of the display. A NO in that column would indicate that
the service was not started. You can use the STATUS display to verify
whether each individual service is started or not, and whether it is
available for local or remote use. This is helpful when using the optional
services list of the NSCONTROL START and STOP functions.
:NSCONTROL STATUS=SERVICES
SERVICE TYPE STARTED SERVER DESCRIPTION
VTA REMOTE YES VTSERVER INCOMING STREAM MODE VIRTUAL TERMINAL
NSSTATL LOCAL YES NSSTATUS OUTGOING NSSTATUS SERVICE
NSSTAT REMOTE YES NSSTATUS INCOMING NSSTATUS SERVICE
LOOPBACK REMOTE YES LOOPBACK INCOMING LOOPBACK SERVICE
RPML LOCAL YES DSSERVER OUTGOING REMOTE PROCESS MANAGEMENT
RPM REMOTE YES DSSERVER INCOMING REMOTE PROCESS MANAGEMENT
PTOPL LOCAL YES DSSERVER OUTGOING PROGRAM-TO-PROGRAM COMMUNICATION
PTOP REMOTE YES DSSERVER INCOMING PROGRAM-TO-PROGRAM COMMUNICATION
RFAL LOCAL YES DSSERVER OUTGOING REMOTE FILE ACCESS
RFA REMOTE YES RASERVER INCOMING REMOTE FILE ACCESS
NFTL LOCAL YES NFT OUTGOING NETWORK FILE TRANSFER
NFT REMOTE YES NFT INCOMING NETWORK FILE TRANSFER
VTRL LOCAL YES VTSERVER OUTGOING REVERSE VIRTUAL TERMINAL
VTR REMOTE YES VTSERVER INCOMING REVERSE VIRTUAL TERMINAL
VTL LOCAL YES VTSERVER OUTGOING VIRTUAL TERMINAL
VT REMOTE YES VTSERVER INCOMING VIRTUAL TERMINAL
Example 2
Example 2 shows the status of the servers. Here the minimum number
of NFT servers is 0 and the maximum is 300 (the defaults). There are no
NFT servers created. The minimum number of VTSERVERS is 6 and the
maximum is 300. One, with process ID number (PIN) 50, is active,
being used for the VT service with session #S1. The other five are not
being used but are in reserve.
:NSCONTROL STATUS=SERVERS
SERVER MIN MAX ACTIVE RESERVED DEBUG PIN JOBNUM STATUS
RASERVER 0 300 0 0 OFF
NSSTATUS 0 300 0 0 OFF
LOOPBACK 0 300 0 0 OFF
VTSERVER 6 300 1 5 OFF
50 #S1 ACTIVE