NS3000/iX Operations and Maintenance Reference Manual (36922-90042)

140 Chapter7
Commands
NETCONTROL UPDATE
NETCONTROL UPDATE
Dynamically updates selected network transport parameters and
configuration information.
Syntax
{INTERNET}
{MAPPING }
NETCONTROL UPDATE= {NETDIR }; {NET= niName }
{X25 } {GATE= gatehalfName }
{ALL }
Parameters
{INTERNET}
{MAPPING } Specifies which configuration areas will be dynamically
UPDATE = {NETDIR } updated. The areas possible depends on the network type.
{X25 }
{ALL }
INTERNET Adds to IPU all gateway data currently configured for
the specified network interface or gateway half,
meaning all gateways appearing in the NMMGR
Neighbor Gateways screen (subtree
NETXPORT.NI.niname.INTERNET) and all Reachable
Network data configured under each of those gateways.
These screens contain information describing the
gateways for all directly connected networks and
gateway halves, as well as all networks the gateways
can reach. Valid for all NI types except Loopback.
MAPPING Adds all router mappings currently configured for the
specified router network interface, to that NI’s mapping
table, meaning all mappings appearing in that NI’s
NMMGR Point-to-Point Mapping Configuration screen
and the Point-to-Point Reachable Nodes screens under
it. Information will be overlaid based on matching
IP-Device mapping records. This allows changing
routes as well as adding new reachable nodes. Valid for
router NI types only.
NETDIR Adds all currently configured Network Directory
(NSDIR.NET.SYS) entries, whose address types apply to
the specified network interface’s type, to the mapping
table for that NI. Valid for LAN, FDDI,
100VG-AnyLAN, 100Base-T and Token Ring NI types
only.