NS3000/iX Operations and Maintenance Reference Manual (36922-90042)

Chapter 7 117
Commands
NETCONTROL ADDLINK
NETCONTROL ADDLINK
Dynamically adds a configured network link to the active network
interface.
Syntax
NETCONTROL ADDLINK= linkName ; {NET= niName }
{GATE= gatehalfName }
Parameters
ADDLINK= linkName
Specifies the name of the link to be dynamically added
to the specified active NI. The linkname must be a valid
NI link name configured in the NMMGR Link Selection
screen and also in the Network Interface Links screen
under the specified “niname” or “gatehalfname” NI. If
already added, an “ALREADY STARTED” error will
occur, or if the linkname is not valid, a “NOT
CONFIGURED” error will occur.
NET=
niName
Specifies the name of an active network interface under
which the specified linkname is configured. Enter any
valid NI name from the NMMGR Network Interface
Configuration screen which is not a gatewayhalf. If this
NI is not active, a “NOT STARTED” error will occur.
GATE=
gatehalfName
Specifies the name of an active gateway half network
interface under which the specified linkname is
configured. Enter any valid gatehalf NI name from the
NMMGR Network Interface Configuration screen. If
this NI is not active, a “NOT STARTED” error will
occur.