NS3000/iX Operations and Maintenance Reference Manual (36922-90042)

110 Chapter7
Commands
LINKCONTROL
found in Appendix A ,
“LINKCONTROL Command.”
CONFIGURATION Prints the information displayed by
the LINKSTATE parameter along with
link configuration information for the
link. The link configuration data
consists mainly of the configuration
information that was input for this link
during NMMGR configuration. The
fields that are displayed by this
parameter are described in Appendix
A , “LINKCONTROL Command.”
LINKSTATE Prints link status information,
including the link name, link type, and
the current status of the link.
DIAGSTATS Prints the information displayed by the
LINKSTATE, CONFIGURATION, and
STATISTICS parameters along with
additional diagnostic statistics.
STATISTICS Prints the information displayed by the
LINKSTATE command and link
statistics, including accumulated error
information. This includes such
information as the number of data
bytes sent and received, and the
number of frames sent and received.
The fields that are displayed by this
parameter are described in Appendix
A , “LINKCONTROL Command.”
RESET Resets the accumulated data and link
statistics that are displayed by the
previously described parameters to 0.
Displays the same fields that are
displayed by the STATISTICS
parameter.
The STATUS and TRACE parameters are mutually
exclusive and may not be specified together in a
LINKCONTROL command.
TRACE Activates link-level tracing. Only one active trace is
allowed per link. If a trace is already active, issuing the
command a second time will result in a TRACE
REQUEST FAILED error message (NMERR 182).
If TRACE is specified, either ON or OFF must also be
specified.