NS3000/iX Error Messages Reference Manual (36923-90043)

554 Chapter21
Logging Location Codes
Dial ID Logging Location Codes
86 CLAS0003 MESSAGE: None
CAUSE: Dial is entering the TIME WAIT state after a normal ack-ack
message.
ACTION: None. Informational only.
87 CLAS0003 MESSAGE: None
CAUSE: A link failure occurred, and Dial is cleaning up the resources
(PARM = status).
ACTION: None. Informational only.
88 CLAS0002 MESSAGE: None
CAUSE: A call to BFMGETBUF failed when attempting to get an outbound
buffer for a reply packet (PARM = result of BFMGETBUF).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
89 CLAS0002 MESSAGE: None
CAUSE: A call to BFMGETBUF failed when attempting to get an outbound
buffer for an acknowledgment packet (PARM = result of BFMGETBUF).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
90 CLAS0002 MESSAGE: None
CAUSE: A call to BFMGETBUF failed when attempting to get an outbound
buffer for an ack-ack packet (PARM = result of BFMGETBUF).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
91 CLAS0002 MESSAGE: None
CAUSE: The Dial ID protocol has waited for approximately five minutes
for transmission of a packet. The connection attempt is aborted.
ACTION: If the link is a manual dial link, then the operator probably
never dialed the phone or replied to the console request. If the link is an
autodial link, then there could be failure with the autocall unit or the
remote node is not answering the phone.
92 CLAS0002 MESSAGE: None
CAUSE: Received an inbound dial request for a route that is already
connected.
ACTION: None.
93 CLAS0002 MESSAGE: None
CAUSE: Timer expired but no matching queue element could be found.
ACTION: None.