NS3000/iX Error Messages Reference Manual (36923-90043)

388 Chapter18
PCI LAPBMUX Link Error Messages
SDI Driver Specific Status Values
61 ($3D) MESSAGE: Bad hardware ID or path.
CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator did not find a supported WAN ACC Sync MUX
adapter card at the hardware path specified in NMCONFIG.
ACTION: Verify the path in NMCONFIG is correct and complete, and
matches the path where a WAN ACC Sync MUX adapter card is
installed in the computer backplane. Verify the Power LED is lit on that
adapter. If necessary, reseat the board or contact your Hewlett-Packard
Representative for hardware assistance.
62 ($3E) MESSAGE: No adapter card found on specified PCI bus.
CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator did not find an HP-PB bus at the hardware
path specified in NMCONFIG.
ACTION: Verify the path in NMCONFIG is correct and complete, and
matches the path where a WAN ACC Sync MUX adapter card is
installed in your computer backplane.If necessary, change NMCONFIG
or contact your Hewlett-Packard Representative for assistance in
determining paths or correcting bus hardware problems.
63 ($3F) MESSAGE: Adapter card found does not match software
configuration.
CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator found a supported adapter card at the path
specified in NMCONFIG, but it was not the right type of card for the
link being started.
ACTION: Correct the network configuration or plug in the correct type of
adapter card, and retry the operation.
64 ($40) MESSAGE: Memory test failed: memory data miscompare.
CAUSE: Upon reaching the end of a diagnostic test of adapter card
memory or LAN controller chip memory, the driver had accumulated at
least one data pattern mismatch.
ACTION: One or more data patterns written by the driver did not match
the data read back from those same memory locations. Depending on
which test was being performed, either the adapter card or LAN
controller chip is faulty. Replace the adapter card.
73 ($49) MESSAGE: Cannot install interrupt handler.
CAUSE: During initial driver startup, the driver was unable to add its
TLIH into the MPE I/O system, as an interrupt handler routine for any
adapter card interrupts on that EIR bit.
ACTION: The driver did not start up. There is probably an MPE
software installation problem, with incomplete or incompatible O/S
software. Verify the system is running an MPE release which supports