NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 17 361
PCI 100Base-T Error Messages
SDI Driver Specific Status Values
7610 CLAS0001 MESSAGE: Unimplemented operation attempted.
CAUSE: While attempting to enable a loopback mode at the request of a
diagnostic tool, the driver detected that the specified mode of looback
support is not available on the PHY.
ACTION: Not all PHY chips support all loopback modes; make sure that
the proper diagnostic request was issued, and that the driver supports
the operation requested. Also make sure that the adapter card is the
correct type and model number, with a revision level that is supported
by the driver software. Contact your Hewlett-Packard representative if
you need assistance.
7620 CLAS0001 MESSAGE: Driver encountered a hardware problem.
CAUSE: While attempting to set loopback mode on the PHY, the ISR
first tried to stop the transmit processing on the adapter card, but
received an error. (“Cause” = 32-bit status from pbt_isr_stop_tx).
Additional errors may have been logged with more information about
the failure.
ACTION: The driver may become unusable or attempt an auto-reset. If
the driver appears to hang, try to shutdown the network manually and
then restart it. Most likely, once the reset is complete and the driver has
“reinitialized” the hardware (card), the driver can resume operating
normally.
If the problem persists, it may indicate a bad adapter card; try
replacing the card.
7650 CLAS0001 MESSAGE: Driver encountered a hardware problem.
CAUSE: While attempting to set loopback mode on the PHY, the ISR
first tried to stop the receive processing on the adapter card, but
received an error. (“Cause” = 32-bit status from pbt_isr_stop_rx).
Additional errors may have been logged with more information about
the failure.
ACTION: The driver may become unusable or attempt an auto-reset. If
the driver appears to hang, try to shutdown the network manually and
then restart it. Most likely, once the reset is complete and the driver has
“reinitialized” the hardware (card), the driver can resume operating
normally.
If the problem persists, it may indicate a bad adapter card; try
replacing the card.
7680 CLAS0001 MESSAGE: Driver encountered a hardware problem.
CAUSE: While attempting to enable loopback mode, the driver
encountered an error while trying to read a register from the PHY
(“Cause” = 32-bit status from pbt_mii_read16).
ACTION: The driver may become unusable or attempt an auto-reset. If
the driver appears to hang, shut down the network manually and then