NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 15 157
LAN, LAN/Console, Token Ring LAN Error Messages
144 MESSAGE: Dump request received when driver is dumping.
CAUSE: Unknown. Need more information.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard representative.
145 MESSAGE: Message received in invalid state.
CAUSE: The link driver received an unexpected message.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard representative.
146 MESSAGE: Driver detected unsupported command in received SDI or
WAN control message.
CAUSE: Unknown. Need more information.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard representative.
147 MESSAGE: Unknown driver problem.
CAUSE: The driver detected an error, but did not say what type of error
was found.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard representative.
148 MESSAGE: Unknown dump manager port number.
CAUSE: The driver detects unrecoverable error and tries to dump its
PDA and the NIO LAN/console card but the dump module is missing.
ACTION: Run NMMAINT to verify that the dump module is present.
149 MESSAGE: Unable to obtain an I/O Services timer for a dump
process.
CAUSE: A call to obtain a timer resource returned an error. Too many
timers may be in use.
ACTION: If you suspect your system might be low on timer resources be
cause of heavy loading, try restarting the link later. If repeated
attempts fail, try warmstarting your system. If the problem persists, a
system dump will be required. Call your Hewlett-Packard
representative.
150 MESSAGE: Unable to send dump request message to dump manager.
CAUSE: A call to a system message SEND routine returned in error. The
dump manager port is not operating with required capabilities.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard representative.