NS3000/iX Error Messages Reference Manual (36923-90043)

126 Chapter12

NETXPORTERR Error Messages

4215 MESSAGE: DTC NAME NOT CONFIGURED IN NMCONFIG PATH

“LINK.linkname”.

CAUSE: The path LINK.linkname was created in NMCONFIG.PUB.SYS,

but the DTC name was not added.

ACTION: Using NMMGR, update the path and validate the DTS

subsystem.

4216 MESSAGE: CANNOT FIND DTC CONFIGURED FOR DEVICE linkname.

CAUSE: This error may be caused by one of the following reasons:

• The host has a non-existent DTC conﬁgured in the

NMCONFIG.PUB.SYS path LINK.linkname.

• The DTC conﬁgured in the NMCONFIG.PUB.SYS path LINK.linkname

is down or ﬂooded.

ACTION: Check the conﬁguration data and verify that it is correct.

Restart the DTC if necessary.

4217 MESSAGE: MAXIMUM X.25 LINKS ALREADY STARTED, CANNOT

START DEVICE linkname.

CAUSE: Too many X.25 links have been started on the host.

ACTION: Stop unused X.25 links or Network Interfaces.

4218 MESSAGE: CANNOT OPEN NETWORK DIRECTORY FILE.

CAUSE: NETCP was unable to open the ﬁle NSDIR.NET.SYS.

ACTION: Check to be sure that the ﬁles NSDIR.NET.SYS and

NSDIRK.NET.SYS exist. If they exist and they are not being accessed by

another process, then try recreating the ﬁles. Otherwise, see Appendix

A , “Submitting a CR,” of this manual.