NetBase for MPE Reference Guide

Using CONFIG
3-13
SPOOL - Spooling Import Priority
This parameter sets the execution priority of all Spooling Import processes. The default is linear
queue 152. Any numeric value or BS, CS, DS, or ES is valid. This parameter takes effect when a
Spooling Import process starts.
Default = 152
Minimum = 50
Maximum = 255
SPOOL - Enable HP-UX Receiving
If this parameter is set to Y, NetBase Spooling from HP-UX will be available. This parameter does
not effect spooling to HP-UX. This parameter takes effect when NetBase Spooling is started.
Default = N
SPOOL - Enable BOOTP Daemon
This parameter causes the BOOTP daemon to be started when NetBase Spooling is started. This
functionality is only available on MPE/iX 4.0 or later. BOOTP is used to configure LAN-based
devices such as printers. This parameter takes effect when NetBase Spooling is started.
Default = N
SPOOL - Enable LPD Daemon
This parameter causes the LPD daemon to be started when NetBase Spooling is started. The LPD
daemon is used to receive spool files from various systems, including UNIX-based systems. This
parameter takes effect when NetBase Spooling is started.
Default = N
SPOOL - Spooling on startup
If this parameter is set to Y, network spooling is operational as soon as NetBase is started. If it is set
to N, spooling must be initialized using the START command in NBCTRL. This parameter takes
effect when NetBase is started.
Default = Y